1. State the assignment (problem/project) in your own words.
2. What are your input factors? (What do you need to know or do before you can begin?) Include the
research you did.
3. Describe the process in detail. Explain the steps you followed in order to complete the project.
4. Describe the final output / product in detail: (what are we looking at?)
7. If you were to do the project again, what would you do differently and why? Provide reasons and examples
- The assignment was to pick up a dixie cup and drive over 3 tables with 3 inch gaps and reach the end of the table with out falling off the table.
2. What are your input factors? (What do you need to know or do before you can begin?) Include the
research you did.
- That our robot must run over the tables with 3 inch gaps while loading a cup and it cannot spill the legos. We didn't use an research
3. Describe the process in detail. Explain the steps you followed in order to complete the project.
- we built the base robot with a set of large wheels and without the claw it functions poorly, we then put the track on the robot and also built a custom arm built into a motor. this time we tested it with a cell phone from the controller and it. then we tested it with the dixie cup and it completed the challenge.
4. Describe the final output / product in detail: (what are we looking at?)
- the final robot was very successful and carried the cup with ease
- we received very good feedback and no comments were no negative
- no we used all the same tools as i did my first time in robotics
7. If you were to do the project again, what would you do differently and why? Provide reasons and examples
- i would change nothing because we were very successful in the initial build and the robot did very well